Yamaha CD-S300 - Manual (Page 7)

English
3
En
IN
TR
ODUC
TI
ON
CONTROLS AND FUNCTIONS
D Playback Status Indicator
Lights up when this unit is in the play or pause mode.
E Source type indicator
Indicates the type of content being played back.
F Time and playback mode indicator
Indicates the current playback mode and the status of the
time display (see pages 5 and 5 for playback modes, and
page 5 for time display).
G Advanced setup indicator
Indicates the enabled special modes. See “USING THE
ADVANCED SETUP” (page 9) for details.
H Multi-information display
Before making any connection, switch OFF the power to the unit, the amplifier and any other component.
■ VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local voltage BEFORE plugging the
power cable into the AC wall outlet. Improper setting of
the VOLTAGE SELECTOR may cause damage to this
unit and create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a straight
slot screwdriver.
Voltages are as follows:
...............AC 110/120/220/230-240 V, 50/60 Hz
Rear panel connections
CAUTION
The audio signals are only output from the ANALOG OUT jacks
when the PURE DIRECT mode is on.
Optical digital
cable
Coaxial
digital
ca
bl
e
Aud
io cable (sup
pl
ied)
Amplifier
Connect the supplied power cable into
the AC IN inlet on the rear panel when
all connections are complete, and then
plug in the power cable to the AC outlet.
CAUTION
230-
240V
VOLTAGE
SELECTOR
Voltage indication