FUNAI CR130TT8 - Manual (Page 21)

21
EN
WATCHING TV
INTRODUCTION
CONNECTION
INITIAL SETTING
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
B. MPAA Rating B. MPAA Rating
MPAA Rating is the rating system created by MPAA (Motion Picture
Association of America).
4
Use [CH K /L] to select “MPAA RATING”, then press
[VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
- V - CHIP SETUP -
TV RATING
MPAA RATING
DOWNLOADABLE RATING
CHANGE PASSWORD
5
Use [CH K /L], then press [VOL X] repeatedly to
change the setting.
or
CH
CH
VOL
G [VIEW]
PG [VIEW]
PG-13 [VIEW]
R [BLOCK]
NC-17 [BLOCK]
X [BLOCK]
Rating Category
G General audience
PG Parental guidance suggested
PG-13 Unsuitable for children under 13
R
Restricted; under 17 requires accompanying
parent or adult guardian
NC-17 No one under 17 admitted
X Mature audience only
6
Press [MENU] to exit.
MENU
C. Change Password C. Change Password
Although the default code “0000” is supplied with the unit, you can set
your own password.
4
Use [CH K /L] to select “CHANGE PASSWORD”, then
press [VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
- V - CHIP SETUP -
TV RATING
MPAA RATING
DOWNLOADABLE RATING
CHANGE PASSWORD
5
Press [the Number buttons] on the remote control to
enter the new 4-digit password.
• Enter password again in “CONFIRM PASSWORD”
space.
3 2 1
6 5 4
9 8
0
7
NEW PASSWORD
_ _ _ _
CONFIRM PASSWORD
_ _ _ _
6
Press [MENU] to exit.
MENU
Note:
• Make sure new password and confirm password must be
exactly the same. If they are different, the space is cleared
for reentering.
• Your password will be erased and return to the default
(0000) when a power failure occurs. If you forget the
password, unplug the power cord for 10 seconds to restore
the password to 0000.