beautypg.com

2 mounting the radar sensor – Furuno DRS4D User Manual

Page 10

background image

4

5. Coat the hex bolts (4 pcs.) with silicone sealant. Fasten the antenna radiator to the radiator

bracket with the hex bolts, flat washers and spring washers supplied with the radiator Then,
apply silicone sealant around the junction part between the radiator and bracket.

6. Apply silicone sealant to holes to prevent water ingress.

1.3.2

Mounting the radar sensor

The radar sensor can be mounted using the fixing holes on the outside (200 x 200 mm) or inside
(140 x 150 mm) the radar sensor.

Using outside fixing holes of radar sensor

Use the hex bolts (supplied) to mount the radar sensor as below.

1. Lay the corrosion-proof rubber mat (supplied) on the mounting platform.

Flat washer

Spring washer

Hex bolt
(M8 x 30)

Radiator bracket

Coat bolts with
silicone sealant.

Antenna
radiator

O-ring

Coat threaded
holes with
silicone sealant.

Radiator bracket, bottom view

(four): Holes
where to apply
silicone sealant.

Apply silicone sealant
around the joint part
with the antenna
radiator.

Rubber mat

Ground terminal

Bow mark

This manual is related to the following products: