FUJITSU FMW43VA1 - Manual (Page 2)

2
2. If the external monitor you wish to connect has power
applied, power it down.
3. Remove the plastic cover that is located over the system
interface port on the bottom edge of the pen tablet. Keep
the cover in a safe place for future reinstallation.
4. Plug the VGA Adapter into the system interface port.
The plug is keyed so that it will only fit when it is posi-
tioned properly (see Figure 3).
5. Insert the video plug into the video connector (see
Figure 2).
6. Restart the system and the external monitor.
To remove the adapter,
1. If the pen tablet is running, either suspend operation or
power down the system.
2. If the monitor you wish to disconnect has power
applied, remove power.
3. Pull the plug from the connector. Replace the plastic
cover over the system interface port.
4. Restart your system.
Note: When the VGA Adapter is attached to the pen
tablet, the tablet cannot be used in the compact desk
stand because the connector/cable assembly extends
too far from the bottom of the system. The system
should be held or laid flat when the VGA Adapter is
installed.
VGAOut.fm Page 2 Monday, August 27, 2001 9:05 AM