Fisher-Price TREEHOUSE 75972 - Manual (Page 6)

Incorrect
Table Top
Ladder
Panel
Correct
Table Top
Ladder
Panel
6
• Make sure the area where the mailbox label will be
applied is clean and dry.
• Bend the mailbox label in half and remove the backing.
• Apply the mailbox label to the mailbox door.
• For best adhesion, try to avoid applying the label more
than once.
Please Note: The mailbox label may already be applied to
the mailbox door.
• Position the wall panel on a flat surface with the outside
facing up.
• Insert one of the mailbox door pegs into one of the hinge
holes in the wall panel.
• Fit and snap the other mailbox door peg into the other
hinge hole in the wall panel.
Hinge
Holes
Pegs Mailbox Door
Mailbox Label
Wall
Panel
Assembly
• Position the assembly so that the ladder panel is laying on
a flat surface.
Helpful Hint: Push the front trunk panel back, to allow for
easier assembly.
• With the table top at an angle, completely insert the tab
on the table top into the slot above the supports on the
ladder panel.
• Rotate the table top toward the supports.
Table
Top
Front Trunk
Panel
Ladder
Panel
Supports
Tab
Ladder
Panel
Tabs
Front Trunk
Panel
Wall
Panel
Telephone
Receiver
• Check to be sure the table top is properly attached to the
ladder panel. There should be no gap between the table
top and the ladder panel.
• Position the assembly so that the front trunk panel is
laying on a flat surface.
• Position the wall panel so that the telephone receiver faces
the ladder panel.
• Insert the tabs on the wall panel into the slots in the front
trunk panel.
• Push down firmly on the wall panel to snap the tabs
in place.