Fujitsu Siemens Computers 4612 FA - Manual (Page 17)

Color monitor 4612 FA
A26361-K628-Z100-1-5E19 English - 9
Connecting cables to the monitor
The monitor ports are protected by a cover.
1
2
3
4
1 = Cover lever
2 = D-SUB connector 3 = DVI connector
4 = Power connector
Ê Press the cover lever (1) to the left and remove the cover.
The data cables provided have a plug for the DVI connection socket on the monitor and a 15-pin D-
SUB plug or a DVI plug for the connection on the computer.
Ê Select the suitable data cable for your computer.
Digital graphics card with DVI interface: DVI connector
Graphics card with VGA interface: D-SUB connector
Information on the computer connections and interfaces is contained in the operating manual for
your computer.
Ê Connect the DVI connector of the data cable to the DVI connector on the monitor (3) and
secure the plug-in connection by tightening the safety screws.
i
If instead of the data cables supplied you want to use a data cable with two 15-pin D-SUB
connectors or if you want to connect the monitor to a second computer, proceed as
follows:
Ê Connect the D-SUB connector of the data cable to the appropriate D-SUB connector
(2) and secure the plug-in connection by tightening the safety screws.
Data cables with two 15-pin D-SUB connectors are available from specialized dealers.
After you have switched on the monitor you must select the desired input using the DVI/D-
SUB button. A message to this effect appears on screen.
Ê Connect the connector of the power cable to the power connector (4) of the monitor and ensure
a secure connection.
Ê Mount the cover over the connections again.