Fujitsu Siemens Computers LifeBook C2111 - Manual (Page 13)

13
Serial/Parallel Port Configuration Submenu of the Advanced Menu
The Serial/Parallel Port Configuration submenu
provides the ability to set the I/O addresses and inter-
rupt levels for the serial (infrared) and parallel ports of
your notebook.
Figure 5. Serial/Parallel Port Configuration Submenu
P O I N T S
n To prevent IRQ and address conflicts, avoid changing
the default settings. If you must change the settings,
you can call 1-800-8FUJITSU for technical assistance.
n The BIOS will warn you of a resource conflict by plac-
ing a yellow asterisk next to each device that is in
conflict.
n All I/O addresses in Table 5 are in hexadecimal.
C A U T I O N
I/O addresses, DMA channels, and Interrupt levels can
be entered in various ways, including via the BIOS setup
utility, the control software for the I/O device, or the
hardware. If any two ports or devices have the same
I/O address assigned, your notebook will not function
normally. Please keep a record of original settings
before making any changes in the event that a
restoration is required. See your hardware and software
documentation as well as the setup utility to determine
settings, limitations, etc.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Advanced
Item Specific Help
Infrared Port: Enabled
Mode: [FIR]
I/O Address: [2E8 - 2EF]
Interrupt: [IRQ 3]
I/O Address: [400 - 43F]
DMA Channel: [DMA 3]
Parallel Port: [Enabled]
Mode: [Bi-directional]
I/O Address: [378-37F]
Interrupt: [IRQ 7]
[Disabled]
The port is disabled.
[Enabled]
The port is enabled
with user configuration.
[Auto]
The port is configured
depending on 'Plug &
Play OS' setting.
Serial/Parallel Port Configurations
A d v a n c e d M e n u
EarthlingBIOS.fm Page 13 Thursday, June 6, 2002 9:15 AM