Falcon SUP1.0K-1C - Manual (Page 10)

15. LCD Metering Display - When the UPS is turned on, this portion of
the LCD display indicates the AC output
voltage initially. Depressing the downward
scroll button will indicate the following each
time it is depressed:
Mode Value Display Description
AC Output Voltage AC Output Voltage
AC Input Voltage AC Input Voltage
AC Output Frequency (Hz) AC Output Frequency
Battery Voltage DC Battery Voltage
Temperature ºC Internal UPS Temperature
Timer Minutes to off The UPS will turn off when the displayed
value reaches zero.
Timer Hours to on The UPS will turn on when the display
reaches zero.
Battery Minutes to off The estimated remaining battery run time
while in battery backup mode.
LCD Metering Display Modes
(use display scroll buttons to change modes; modes are in descending order)
2
5
4
3
NEMA Type
IEC Type
Battery Fuse
Step 1C
Battery Fuses
TYPICAL UPS REAR PANEL
1. Battery Disconnect Jumper - To install the Jumper use the
following procedure.
a) Using a #1 Phillips screwdriver remove the two screws securing
the battery disconnect cover.
b) Remove the battery disconnect jumper plug from the plastic bag.
c) Press the disconnect jumper into the socket visible through the
hole exposed after removal of the cover. A small popping sound
may occur; this is normal.
9
JUMPER
JUMPER SLOT
2
3
4
1
5 6