FRIGIDAIRE 318200944 - Manual (Page 10)

10
Care & Cleaning
(Cleaning Chart)
Surfaces
Aluminum (Trim Pieces)
& Vinyl
Painted and Plastic Parts,
Body Parts, Control Panel
and Decorative Trim
Easy Care™ Stainless
Steel (some models)
Oven Door, Control Panel and
Decorative Trim
Porcelain Enamel,
Broiler Pan and Insert, Door
Liner, Body Parts
Oven Racks
Oven Door
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all-purpose
cleaners, ammonia, powdered cleaners or commercial oven cleaner. They can scratch
and discolor aluminum.
Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of vinegar
and water. Follow by rinsing the area with clean water; dry and polish with a soft cloth.
Glass cleaners may be used if sprayed on a soft cloth first. DO NOT spray liquids directly
on the control pad and display area. Do not use large amounts of water on the control panel
- excess water on the control area may cause damage to the appliance. Do not use other
liquid cleaners, abrasive cleaners, scouring pads, or paper towels - they will damage the
finish.
Before cleaning the control panel, turn all controls to OFF.
Your appliance finish is made with Easy Care™ Stainless Steel (some models).
Clean the stainless with warm soapy water using a clean sponge or cloth. Rinse with
clean water and dry with a soft clean cloth. DO NOT use ANY store bought cleaners
like Stainless Steel cleaners or any other types of cleaners containing any abrasive,
chlorides, chlorines or ammonia. It is recommended to use mild dish soap and water
or a 50/50 solution of water and vinegar.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1
solution of clear water and ammonia.
If necessary, cover difficult spots with an
ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a
damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with a
clean cloth. Remove all cleaners or the porcelain may become damaged during future
heating. DO NOT use spray oven cleaners.
Oven racks may be removed or left in the oven during the Self-Clean cycle for
cleaning. If removed, clean by using a mild, abrasive cleaner following manufacturer's
instructions. Rinse with clean water and dry.
If the racks are cleaned in the Self-Clean cycle, their color will turn slightly blue and
the finish will be dull. After the Self-Clean cycle is complete, and the oven has
cooled, rub the sides of the racks with wax paper or a cloth containing a small
amount of salad oil (this will make the racks glide easier into the rack positions).
Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse
well. You may use a glass cleaner on the outside glass of the oven door. DO NOT
immerse the door in water. DO NOT spray or allow water or the glass cleaner to
enter the door vents. DO NOT use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
DO NOT clean the oven door gasket. The oven door gasket is made of a woven
material, on Self-Cleaning models, which is essential for a good seal. Care should be
taken not to rub, damage or remove this gasket.
DO Hand
Clean Frame
DO Hand
Clean Door
DO NOT
Hand Clean
Oven Door
Gasket