FORD 2000 Focus - Manual (Page 187)

Maintenance and care
187
• If the oil level is between the
MIN and MAX marks (2.0 SPI
engine) or between ADD and
FULL (2.0 ZetecĆengine), the oil
level is acceptable. DO NOT ADD
OIL.
• If the oil level is below the MIN
mark, add enough oil to raise the
level within the MIN-MAX range.
• Oil levels above the MAX mark
may cause engine damage. Some oil
must be removed from the engine
by a service technician.
7. Put the indicator back in and
ensure it is fully seated.
Adding engine oil
1. Check the engine oil. For
instructions, refer to Checking the
engine oil in this chapter.
2. If the engine oil level is not
within the MIN and MAX ranges,
add only certified engine oil of the
recommended viscosity. Remove
the engine oil filler cap and use a
funnel to pour the engine oil into
the opening.
3. Recheck the oil level. Make
sure the oil level is not above
the MAX mark (2.0 SPI engine)
or the FULL mark (2.0 ZetecĆ
engine) on the dipstick.
4. Replace oil filler cap and ensure
it is fully tightened.
2.0 SPI engine
2.0 ZetecĆengine