FUJITSU MHS2040AT - Manual (Page 30)

2.1 Spare Parts Removal and Replacement Procedure
2-2 C141-F059-01EN
2.1 Spare Parts
See Table 2.1 for the model and parts numbers to order the replacement disk
drive.
Table 2.1 Model and parts numbers
Model Part number Formatted
capacity
Mounting screw
MHS2060AT CA06272-B042 60 GB
MHS2040AT CA06272-
B83100DX
40 GB
MHS2030AT CA06272-B022 30 GB
MHS2020AT CA06272-
B82200DY
20 GB
M3 (depth 3)
2.2 Disk Drive Removal
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, is as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag.
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
Damage or Device damage
1. Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
2. Do not move the drive until it comes to a complete stop (about
30 s after the power is turned OFF).
3. Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)