Fostex VF-16 - Manual (Page 17)

17
AUTO PUNCH
RECORD PLAY STOP F FWD REWIND
NEXT PREV CLIPBOARD PLAY
L O C AT E A B S 0
LOCATE REC END
FADER
ADJUST
SHIFT
LEVEL
ADJUST
EXIT/NO
ENTER/YES
EJECT
JOG
SHUTTLE
DISP SEL REC TRK
END
MARK
DIRECT
CLIPBOARD
BUSS
AUTO RTN
AUTO PUNCH
REC ASSIGN
REC TRK SOURCE INPUT SEL
START
TIMEBASE
SCENE SEQ.
P.EDIT
VARI
PITCH
ALIGN SEL
SETUP
SCRUB
A RTN
A PLAY
PGM SEL
OUT OUT
LOCATE
EVT MEM
IN IN
4 1 6 7 3 5 2
UNDO/
REDO HOLD/ EDIT STORE
43
56
35
34
33
32
52
53
54
55
51
50
40
41
47
48
49
25 26 27 28 29 30 31
42
44
36
37
38
39
46
45
Recorder Section
25. [INPUT SEL] Key
* Set whether to send the A to H input signals [INPUT]
or track 9-16 play [TRACK] sounds to the faders of
channel faders 9 to 16.
26. [REC ASSIGN-BUSS-SOURCE] Key
* Select the channel (SOURCE) to send to the REC BUSS
during “BUSS” recording. Select the SOURCE channel
with the [CH STATUS/CH SEL] key.
* This key lights ON when the SOURCE is selected.
27. [REC ASSIGN-BUSS-REC TRK] Key
* The track (READY) to record in “BUSS” recording is
selectable when this key is flashing. Set READY track
with the [CH STATUS/CH SEL] Key.
* This key lights ON when the READY track is set for
“BUSS” recording.
28. [REC ASSIGN-DIRECT-REC TRK] Key
* The track (READY) record in “DIRECT” recording is
selectable when this key is flashing. Set READY track
with the [CH STATUS/CH SEL] key.
* This key lights ON when the READY track is set for
“DIRECT” recording.
29. [DISP SEL/TIMEBASE] Key
* This key is used to alternate the menu shown on the
LCD in the following order.
* The tracks recorded vary, as shown below, according
to the connection jack.
a. Current location of TIME BASE selected
Shows the current location of the sound.
b. REMAINING TIME BASE Selected (time remaining)
Shows the time remaining and space available on the
disk for recordings (in terms of mono track).
c. MTC Time Input
Shows the MTC time input in the [MIDI IN] jack.
This is a convenience for operations as a slave device.
* The user can switch between time bases, as shown
below, by pressing the [DISP SEL/TIME BASE] key,
while the [SHIFT] key is depressed.
a. ABS (Absolute Time) Indication
An absolute time base from 00H 00M 00S (ABS 0) to
24H 00M 00S.
b. BAR/BEAT/CLK (Bar)
The “Bar, Beat, Clock” of the beat and tempo set with
the internal tempo map.
c. MTC (MIDI Time Code)
Display of the MTC time setting.
30. [PGM SEL] Key
* This is used to switch between programs 01 to 99.
This is also used to create new programs.
31. [SETUP] Key
* This is used to go into the setup mode to set various
parameters of the recorder and mixer.