Frontier Labs Lite/Pro User Manual
Page 12
Chapter 2 — Getting Started
7
Preset voltage setting for MSR
1. The MSR default setting is ISO Track 1 & 2. (For customized track settings,
advise the manufacturer before production.)
2. In event of any requirement to change the setting of the MSR, run Setting
utility in the driver CD provided in the accessory package.
3. The normal swiping card speed of the MSR is 10 to 100 cm/sec. (based on
the ISO 7812 standard).
L
L
i
i
m
m
i
i
t
t
a
a
t
t
i
i
o
o
n
n
s
s
Connector with
Voltage Output
Location
Average current
Pack current
COM 1 for External input
device interface
LCD Panel Side
DC 5V / 0.5A,
DC 12V / 0.5A
DC 5V / 1A,
DC 12V / 0.5A
COM 2 for Touch Panel
interface
LCD Panel Side
DC 5V / 0.3A
DC 5V / 0.5A
COM 3 for extension
interface (9
th
PIN of DB-9)
LCD Panel Side
(On Mother Card)
DC 5V / 0.3A,
DC 12V / 0.5A
DC 5V / 0.5A,
DC 12V / 1A
COM 4 for extension
interface (9
th
PIN of DB-9)
Bottom side (On
Interface Board)
DC 5V / 0.3A,
DC 12V / 0.5A
DC 5V / 0.5A,
DC 12V / 1A
COM 5 for Pole Display
(RJ-45)
Bottom side (On
Interface Board)
DC 5V/ 1A
DC 12V/ 1A
DC 5V / 1A,
DC 12V / 1A
COM 6 for Cash Drawer
driving (Pulse)
Internal connector
DC 12V / 1A
DC 24V / 1A
DC 12V / 1A,
DC 24V / 1A
DC 12V Powered USB for
peripherals
Bottom side (On
Interface Board)
DC 12V / 1.5A
DC 12V / 2.5A
DC 24V Powered USB for
peripherals
Bottom side (On
Interface Board)
DC 24V/ 1.5A
DC 24V / 2A
*2
nd
LCD Monitor Power
Connector (DC Plug)
Bottom side (On
Interface Board)
DC 12V / 1.5A
DC 12V / 2.5A
*DC 24V Printer Power
Connector (Hosiden
3PIN)
Bottom side (On
Interface Board)
DC 24V/ 1.5A
DC 24V / 2A
Note:
• None of the COM Port current loading should exceed DC 5V/3A+ DC 12V/2A.
• DC 12V /24V powered USB should not be used with 12V DC plug and 24V Hosiden
at the same time.
• When 2nd Display uses 12V DC plug, the thermal printer can NOT use the 24V
Hosiden simultaneously.