FUJITSU FD-1008AT - Manual (Page 15)

12
DIP Switch Settings
The factory default settings are as follows:
1 2 3 4 5 6 7 8
ON
OFF
(*Note: the indicates the switch position)
DIP Switch Functions
SW No. Function ON state / OFF state
1 Hot Key Mode:
++ and
Hot-Key SW ON: enabled / OFF: disabled
2 Hot Key Mode: Double ON: enabled / OFF: disabled
3 Hot Key Mode: Double Lock> ON: enabled / OFF: disabled
4 Country Setting bit 1 (see following table)
5 Country Setting bit 2 (see following table)
6 Country Setting bit 3 (see following table)
7 Country Setting bit 4 (see following table)
8 Power Mode Setting ON: the switch device is always ON.
OFF: the switch device turns ON if any
connected host is turned ON.
The country code (language) settings are as follows: For Sun Microsystems plat home only
Country Setting
SW4 SW5 SW6 SW7
JPN ON ON ON ON
USA ON ON ON OFF
GBR ON ON OFF ON
GER ON ON OFF OFF
FRA ON OFF ON ON
ESP ON OFF ON OFF
SWE ON OFF OFF ON
POR ON OFF OFF OFF
TPE OFF ON ON ON
KOR OFF ON ON OFF
ITA OFF ON OFF ON
UNIX OFF ON OFF OFF
NOR OFF OFF ON ON
BEL OFF OFF ON OFF
DEN OFF OFF OFF ON