beautypg.com

Important – Fisher & Paykel DD60S 7 User Manual

Page 21

background image

21

2

2

1

ATTACH PANEL TO PRODUCT

ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS

20b

22b

21b

With the front panel fitted, insert an appropriately
sized Philips screwdriver into the hole above the
door pin and rotate the panel up or down to align
the gaps in your cabinetry.

Repeat on the other side if necessary.

The panel has a maximum travel of 2 mm up or
down.

Important!

Ensure that you maintain a minimum of 8 mm ventilation
gap below the panel.

+ or - 2 mm

Important!

Ensure the rubber seal
between the drawer
and panels is kept in
place.

When refitting the

door pins, ensure

they are

orientated as shown.

Push the panel in

then up to locate.

INTEGRATED MODELS WITH BADGE (GB IE) ONLY - INSTALLING THE FRONT PANEL & BADGE CONTROLS

REATTACH BADGE & EARTH THE PANEL

1

2

WARNING!

Electrical Shock Hazard

Connect the integrated badge
earth wire to one of the two tabs
provided on the panel bracket.
To earth the panel bracket,
connect the earth wire from the
product to the other tab.
Any custom metal component
(e.g. handle) that extends past the
rubber seal must be earthed too.
Failure to follow these warnings
may result in electrical shock,
injury or fi re.

This manual is related to the following products: