FRIGIDAIRE 134670300 User Manual

Page 8

Avoid Ser

void Ser

void Service

vice

Checklist

Before calling for service, review this list. It may save both time and expense. The list includes
common concerns that are not the result of defective workmanship or materials in this washer.

NOISE

This is normal.

Stop washer and check tub. If noise continues after
washer is restarted, objects may be in pump. Call your
authorized servicer.

To prevent unnecessary noise and damage to tub,
fasten fasteners and turn items inside out.

Do not overload washer. Stop washer and reduce
load.

This is usually normal. If sound continues, washer is
probably out of balance. Stop washer and redistribute
wash load.

Move washer so it rests firmly on floor. Adjust leveling
legs. See INSTALLATION INSTRUCTIONS for details.

See INSTALLATION INSTRUCTIONS for removing
shipping bolt and block.

Stop washer and rearrange wash load.

Make sure plug fits tightly in wall outlet.

Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If problem is a circuit overload, have it
corrected by a qualified electrician. If problem is a
power outage, call local electric company.

Turn on water supply faucets.

Move indicator clockwise slightly. Pull out knob.

Washer motor will stop if it becomes overheated. It
will automatically restart after a cool down period of
up to 30 minutes (if washer has not been manually
turned off).

Close lid completely.

Wipe tub with a nonabrasive household cleanser, then
rinse. Shake or brush excess dirt and sand from items
before washing.

"Clunking"or
gear sounds.

Rattling and clanking
noise.

Squealing sound or hot
rubber odor.

Thumping sound.

Vibrating noise.

Washer does not start.

Washer won't spin.

Residue left in tub.

A certain amount of "clunking" or gear
sounds are normal in a heavy-duty
washer.

Foreign objects such as coins or safety
pins may be in tub or pump.

Belt buckles and metal fasteners are
hitting wash tub.

Washer is overloaded.

Heavy wash loads may produce a
thumping sound.

Washer is not resting firmly on floor.

Shipping bolt and block have not been
removed during installation.

Wash load unevenly distributed in tub.

Electrical power cord may not be plugged
in or connection may be loose.

House fuse blown, circuit breaker tripped,
or a power outage has occurred.

Water supply faucets are not turned on.

Cycle selector is not in correct position.

Motor is overheated.

Lid is not completely closed.

Heavily soiled items.

OPERATING

POSSIBLE CAUSE

SOLUTION

OCCURRENCE