Field Controls UV-12 - Manual (Page 5)

page 5
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands.
Determine whether to use flat or angled bracket. (Refer to UV-Aire “Bulb 5.
Mounting Bracket Selection” for aid in this decision)
a. Flat Bracket Installation
i. Remove the two hex nuts and flat bracket from included
bagged hardware.
ii. Install the flat bracket and secure to the unit base with the hex nuts
provided. (See Figure 13)
b. Angled Bracket Installation
NOTE: For angled bracket mounting, refer to specifications outlined by
Diagrams A & B for mounting distances in the “Angled Lamp Mounting
Bracket Specifications” section.
i. Remove the two hex nuts and angled bracket from included
bagged hardware.
ii. Install the angled bracket and secure to the unit base with the hex nuts
provided. (See Figure 14)
NOTE: Be sure to note location of lamp hole in bracket relative to unit base.
Mount the unit base to the duct using the four mounting screws provided. 6.
(See Figure 15)
Remove tag and alcohol from lamp. Wipe off lamp being sure not to ouch 7.
lamp with bare hands. The oils from your hands will reduce lamp output.
Insert lamp through hole until lamp cannot be inserted any further. 8.
(See Figure 16)
Swing swivel bracket over end of lamp. Hand-tighten the wing nut on stud. (See 9.
Figure 17) Be careful not to over tighten the wing nut. The porcelain at the lamp
base may crack when over tightened.
Plug ballast plug into end of lamp. (See Figure 18) 10.
Figure 15
Figure 14
Figure 13
Figure 16 Figure 17 Figure 18