FieldServer Gamewell FS-8700-83 - Manual (Page 8)

FS-8700-83 Gamewell Page 6 of 24
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: [email protected]
4.4 Client Side Map Descriptors
FieldServer Related Map Descriptor Parameters
Column Title Function Legal Values
Map_Descriptor_Name Name of this Map Descriptor Up to 32 alphanumeric
characters
Data_Array_Name Name of Data Array where data
is to be stored in the Bridge One of the Data Array names
from “Data Array” section above
Data_Array_Location Starting location in Data Array 0 to maximum specified in
“Data Array” section above
Function Function of Client Map
Descriptor.
Reads (rdbc / rdb ) are not
allowed. The use of WRBX is
recommended for the ack /
silence / reset functions. A
message will be generated
each time the value in the
associated array is updated
(even if the value stays the
same.)
Passive, WRBC, WRBX
Driver Related Map Descriptor Parameters
Column Title Function Legal Values
Node_Name Name of Node to fetch data
from One of the node names
specified in “Client Node
Descriptor” above
Data_Type Data type
This parameter is only required
for passive / server map
descriptors.
The Data Type determines the
type of data that gets stored
when a message get received.
The Data Type corresponds to
the ‘Status’ field in a Gamewell
message.
Additional information is
provided in section 6.2
Any
Alarms
Faults
Events
Bus
Comm
Control
Ack
Signal Silence
Troubles
Supervisories
Action_Numbers
Action_Bits
Dump