beautypg.com

Installation instructions, Mount the microwave oven, Check for proper damper operation – FRIGIDAIRE 316495063 User Manual

Page 14: A4. a5

background image

3

MOUNT THE MICROWAVE
OVEN

FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.

IMPORTANT: Do not grip or use handle

during installation.

NOTE: If your cabinet is metal, use the nylon

grommet around the power cord hole to prevent
cutting of the cord.

NOTE: We recommend using filler blocks if the

cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are

not used, case damage may occur from

overtightening screws.

Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.

2 Rotate front of oven

up against cabinet
bottom.

NOTE: When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.

Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.

1

CHECK FOR PROPER
DAMPER OPERATION

Exhaust Adaptor

Blower Plate

Damper

Back of

Microwave

Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.

You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.

A3.

ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST

Secure blower unit to microwave with the screw

5

removed in Step 1. Make sure the screw is tight.

Replace blower plate with the screw removed in
Step 1. Make sure the screw is tight.

Back of

Microwave

6

7

Back of

Microwave

Guide

Adaptor

Locking Tab

damper swings freely.

Attach the exhaust adaptor to the top of the
blower plate by sliding it into the guides of the

blower plate.

Push in securely until it is in the locking tabs.

Take care to assure that the damper hinge is

installed so that the

A4.

A5.

Installation Instructions

14

This manual is related to the following products: