FRIGIDAIRE RH36WC60GS - Manual (Page 13)

13
Making the electrical connections
Electrical Shock Hazard
wiring this unit.
к2ы V
к2ы V к2ы V к2ы V к2ы V AC, ê5 or 2û Amp cir AC, ê5 or 2û Amp cir AC, ê5 or 2û Amp cir AC, ê5 or 2û Amp cir AC, ê5 or 2û Amp cir cuit r cuit r cuit r cuit r cuit requir equir equir equir equired. ed. ed. ed. ed.
ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL
JUNCTION BOX WITH À WIRES, ONE OF WHICH
ôGREEN/YELLOWÈ SERVES TO GROUND THE
APPLIANCE. TO PROTECT YOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failur
Failur Failur Failur Failure to do so can r e to do so can r e to do so can r e to do so can r e to do so can result in death or electrical esult in death or electrical esult in death or electrical esult in death or electrical esult in death or electrical
shock. shock. shock. shock. shock.
Remove junction box cover and knockout on the
top left side.
If not already done, install ê/2” conduit connector
in junction box.
Run black ôliveÈ, white ôneutralÈ, and green ôearthÈ
wires фн кщ AWGÈ according to the National
Electrical Code or CSA Standards and local
codes and ordinances in ê/2” conduit from power
supply to junction box.
Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in junction box respectively.
These connections should be done always
making reference to the electrical diagram found
inside the hood.
Close junction box cover and reapply screws.
Installing the hood