Franklin RDC-525 - Manual (Page 33)

Using a Password
You can use a password to keep the
information in the databank private. The
password is requested when the unit is
turned on and the databank is accessed.
Password Warnings
Warning! After you set the password, you
must enter the password to access the
databank for the first time during a session.
Always record your password and keep it in
a separate place.
If you forget the password, you must reset
the unit to access the databank. Warning!
Resetting the unit erases all user-entered
information. Always keep written copies of
your data. Use the end of a straightened
paper clip to gently press the reset button. If
the unit does not reset after pressing the
reset button, remove the batteries, wait at
least two minutes, and then re-install them.
For battery instructions, see “Replacing the
Battery”.