Festool RO 125 FEQ - Manual (Page 8)

8
removal (coarse sanding) and polish-
ing.
Slide the switch (6.1) into the right posi-
tion.
Eccentric motion (fi ne sanding)
This motion is recommended for
sanding with low material removal for
a scratch-free fi nish (fi ne sanding).
Press the switch (6.1) down and push it into
the left-hand position.
Choice and installation of sand-
ing pads
Choice of sanding pad
The tool can be fi tted with three sanding
pads of different hardnesses depending on
the surface to be sanded.
Hard: Coarse sanding on surfaces, sanding
at edges.
Soft: Universal use for coarse and fi ne
sanding for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts,
curves, radii. Do not use on edges!
Installation
The FastFix system enables tool-free re-
placement of the sanding pad:
- Set the switch (7.1) to the right for the
Rotex rotary motion,
- Press spindle stop (7.3), direction of move-
ment fi rst to the side, then forwards,
- Turn the fi tted sanding disk (7.2) from the
spindle (right-handed thread),
- Keep the spindle stop pressed and screw
on the new sanding pad (in doing so, make
sure that the rubber collar (10.1) is cor-
rectly fi tted!),
- Let go of the spindle stop.
Actuate the spindle stop only
when the drive spindle is stationary. Do not
switch on the motor when the spindle stop
is pressed in.
7.3
7.1
7.2