FujiFilm MP-300 - Manual (Page 5)

8 9
2, Owner’s Manual c
FPT-608106-FP-01
The owner’s manual
Getting Ready Getting Ready
Printing Printing
Advanced Printing Advanced Printing
Error Error
en: The owner’s manual in English and French is available at “http://home.fujifilm. com/products/dmp.” fr: Le manuel d’utilisation en Anglais et en Français est disponible sur le site “http://home.fujifilm.com/products/dmp.”
1, Lithium Batteries
(CR2)
3, Mobile Printer
MP-300
Introduction
Contents of package
(P.18)
About IrSimple™
■ What is IrSimple™?
IrSimple™ is a high-speed infrared communication protocol that
permits high-speed data transfer. It was adopted in August 2005 as an
international standard by the IrDA
® (Infrared Data Association ® ), which
is the standardization body for infrared technology.
IrSimple uses the same physical interfaces (SIR/FIR) as the existing
IrDA standard and has the following 2 communication modes:
zUnidirectional
In this mode, data is only sent in one direction: from the sending device (primary
node). Problems that arise during communication cannot be corrected.
zBidirectional
This is a bidirectional mode in which the receiving device (secondary node)
responds to data sent from the sending device (primary node) by sending
the outcome of the data reception or requesting a resend, etc. This allows
problems that arise during communication to be corrected.
■ What is IrSimpleShot™ (IrSS™)?
This is a generic name given to unidirectional IrSimple™ communication.
■
IrSimple™ compatibility on the MP-300
The MP-300 supports both IrSimpleShot communication mode and
bidirectional communication mode.
■ Restrictions on IrSimple™ on the MP-300
zThe MP-300 can only operate as a receiving device (secondary node).
zThe MP-300 will only receive IrSimpleShot communication from a sending
device equipped with a high-speed infrared communication function (FIR).
(The MP-300 does not support IrSimpleShot communication using SIR.)
zWhen a sending device equipped with a high-speed infrared
communication function (FIR) uses FIR to make an IrSimpleShot
transmission to the MP-300, the MP-300 can only receive data up to 1 MB
in size. (It cannot receive fi les larger than 1 MB.)
Note also that, depending on the transmission conditions (transmitted
packet size, etc.), the MP-300 may be unable to receive data from a
sending device even if it meets the above requirements.
■ IrSimple™ transmission speed
zSee “Guide to image sizes and transmission times” on P.27.
z IrSimple™, IrSimpleShot™ and IrSS™ are trademarks of the Infrared Data
Association ® .
z“ ” and Image Intelligence™ are trademarks of Fuji Photo Film Co., Ltd.
zAll other company, organization or product names used in this document are
trademarks or registered trademarks of their respective holders in Japan or other
countries. Note that the ™ and
® symbols may be omitted in some instances in
this document.
c The design of the cover page of Owner’s manual may differ depending on the regions.