FRIGIDAIRE 316495064 - Manual (Page 6)

Find the studs, using one of the following
methods:
A.
Stud finder – a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16
″ (40.6 cm) or 24″ (61 cm) from this mark.
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
1
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
FINDING THE WALL STUDS B
.
A
.
2
PLACEMENT OF THE MOUNTING PLATE 1
Wall
Studs
Center
3
Carton
Pull the carton up and off the oven.
Remove the screws from the mounting plate.
This plate will be used as the rear wall template
holes where they were removed.
Mounting
Plate
Screws
2
Styrofoam
Installation Instructions
3
5
4
1
tray and the small hardware bag. Do not remove
the Styrofoam.
the Styrofoam protecting the front of the oven.
Remove the installation instructions, filters, glass
Cut the middle of plastic bag
r
6
and for mounting. Reinstall the screws into the
to
emove the ounting late m p