Flaircomm Technologies GPSBT560 - Manual (Page 11)

GPSBT560 User Manual
. 11
3. Important Messages and Frequently Asked Questions
1. Red LED gives two quick blinks every minute.
Low battery indicator; please recharge your battery as soon as possible.
2. Can't power up the device after charging more than 20 minutes：
For the first time, the device should be charged at least 40 minute prior tuning on, it is recommended that the
battery should be fully charged before using the device.
3. Receiver can not be found when a device tries to pair with it：
Your receiver may not be in the pairing mode or within the operation range (i.e., 10 meters), please refer section
2.5.1 for details.
4. Do the paired receiver or the paired Bluetooth device need to be re-paired power off：
No.
5. Slow GPS position tracking and poor location accuracy
The GPS signal could be very weak. You need to ensure the receiver is placed with the top side facing up to the sky.
However, this may not necessary lead to better signal strength due to other causes such as weather conditions.
6. Slow cold start time
This is typically happens when you go to a new area and turn the device on or on the first-time use, of the receiver.
In these cases, either the previous recorded geo-location data were too far away from the new location or no initial
geo-location data can be used for cold start reference.