FORD 2005 F-150 - Manual (Page 72)

Erasing HomeLink ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or
learning) mode and can be programmed at any time beginning with Step
2 in the “Programming” section.
Reprogramming a single HomeLink
ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
௡ button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
௡ button, follow Step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
MESSAGE CENTER (IF EQUIPPED)
With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems. You may select
display features on the message center for a display of status preceded
by a brief indicator chime. The system will also notify you of potential
vehicle problems with a display of system warnings followed by a long
indicator chime. If equipped with an outside temperature display, it will
display in the instrument cluster all the time, except when a warning
message is present.
2005 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
72