FUNAI CR320IL8 User Manual

Page 14

Set the AUTO PRESET CH.

Here describes the case for searching and
memorizing channels for TV/DTV.

• Using [CH K/L], select "AUTO PRESET

CH(TV/DTV)".

• When you press [VOL X], the channel scanning

in both analog and digital modes will automati-
cally start.

• When scanning is completed, the lowest mem-

orized channel will be displayed.

NOTES:

• The initial AUTO PRESET CH function can be executed for

either TV/DTV or CATV only once. If you want to scan both
TV/DTV and CATV, you need to select "CHANNEL SET" in
the MENU screen to scan and memorize other channels after
initial presetting is completed. (Refer to page 28.)

• You can exit the initial AUTO PRESET menu by pressing

[MENU].

• When you press [MENU] while scanning, the scanning is

interrupted and the lowest memorized channel is displayed.

• If you press [POWER], the power will be turned off. When

the scanning is not completed, initial AUTO PRESET CH
screen is displayed every time you turn on the power.

• When no channel can be received by AUTO PRESET CH,

"NO TV SIGNALS" is displayed on the screen.

NO TV SIGNALS

AUTO PRESET CH(TV/DTV)

1. PLEASE CONNECT ANTENNA TO
THE UNIT.
2. SET UP THE ITEMS WITH
, AND BUTTONS.

D.S.T. (Daylight Saving) [ON]

TIME ZONE

[ALASKA]

AUTO PRESET CH (TV/DTV)
AUTO PRESET CH (CATV)

NOTES:

• If "D.S.T. (Daylight Saving)" and "TIME ZONE" is not set,

you cannot select "AUTO PRESET CH".

• Make sure if the TV is connected to antenna or cable.

When antenna is connected, select “AUTO PRESET CH
(TV/DTV)” at the procedure below. When connected to
CATV, select “AUTO PRESET CH (CATV)”.