FRIGIDAIRE 6.75E+11 - Manual (Page 5)

5
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart). The
indicator light above the pad will glow when
selected.
5. Select desired OPTIONS (See Energy Options). The
indicator light above the pad will glow when
selected.
6. Run hot water faucet nearest dishwasher until water
is hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
NOTE
The dishwasher is programmed to remember your last cycle
so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on
the previous wash, just press the START/CANCEL pad.
Wash Cycle Selections
Cycle times are approximate and will vary with options
selected. Hot water is necessary to activate dishwasher
detergent and melt fatty food soils. An automatic sensor
will check the incoming water temperature and, if it is
not hot enough, the timer will be delayed for automatic
water heating in the main wash of all cycles. This
happens even when HI-TEMP WASH option has not been
selected. When HI-TEMP WASH is selected, an even
higher temperature will be guaranteed to handle heavier
soil loads.
OPERATING INSTRUCTIONS
Options Selections
Getting Started
Hi-Temp Wash
When HI-TEMP WASH option is selected, the dishwasher
heats water in the main wash to approximately 140°F
(60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil from
dishes more effectively and aids in drying. This option is
available in NORMAL WASH and LIGHT WASH. HI-TEMP
WASH is automatically provided when HEAVY WASH cycle is
selected.
NOTE
Lights and Display on top of console will shut off when the
door is closed. They will light up when the door is opened
and display time remaining will be displayed for several
seconds. Then “Cd” will display flashing, informing you to
close the door so the cycle can continue.