Frymaster D50 Series - Manual (Page 33)

DECATHLON SERIES GAS FRYERS (CE)
CHAPTER 5: THERMATRON OPERATION
5–2
5.1 Operating Fryers with Thermatron Controllers (cont.)
MAIN POWER SWITCH – connects/disconnects primary power; double-lighted with center
position "OFF". One main switch controls two Thermatron controllers/Compu-Fry computers
and/or two back-up thermostats. When the Main Power Switch is in the center position, power is
removed from the two fryers controlled by the Thermatron controller/Compu-Fry computer or back-
up thermostats. When the Main Power Switch pressed to the right, power is supplied to the
Thermatron/Compu-Fry computer of each fryer. When pressed to the left, power is supplied to the
back-up thermostat of each fryer. The back-up thermostat should be left in the "OFF" position when
not in use (Newer fryers may not have the backup control option).
INDIVIDUAL FRYER POWER SWITCH – this switch controls power to the individual fryer,
whether the fryer is in the Thermatron/Computer mode or the back-up mode. When the power
switch is in the "ON" position, the indicator light will be lighted when calling for heat. The power
switch only removes power from the temperature control circuit (Thermatron and Back-Up
Thermostat). The power switch should be in the "OFF" position during filtering.
BOIL-OUT SWITCH – this only operates when in the Thermatron mode. When the Boil-Out
switch is "ON", it will bypass the Thermatron Melt Cycle, and allow the water temperature to reach
approximately 196°F.
HIGH-LIMIT RESET – Located under control panel. Must be manually reset if the fryer exceeds
high-limit setpoint.
FILTER RESET BREAKER (7 Amp Circuit Breaker- 120VAC or 5 Amp Circuit Breaker-
230VAC) – the breaker is in line between the filter switch and the pump. Ensure filter power is off
prior to resetting or replacing.
5 AMP (115VAC) or 2 AMP (230VAC) FUSE – each fryer circuit is protected by a 5 amp
(115VAC) or 2 amp (230VAC) fuse located under the control panel.