beautypg.com

Operating instructions, Very important information, Normal operating sounds – FRIGIDAIRE 400 User Manual

Page 4: Delay start/status lights, Getting started, Read before operating your dishwasher

background image

4

Very Important Information—

Read Before Operating Your

Dishwasher!

Normal Operating

Sounds

This dishwasher does not sound like most

dishwashers—IT’S QUIETER!
The new wash system uses energy efficient

motors for the wash and drain portions of the

cycle you select. Each cycle has a series of

water fills and drains for washing and rinsing

dishes. As each cycle begins, you may–or may

not–hear the drain motor.
The next sound you will hear is the splashing

water as it enters the tub. Then the lower arm

rotates and circulates water. This is followed

by a pause and a slightly different sound as

the upper arm sprays water. If you listen

closely, you will hear the change in sound as

the wash action switches from one arm to the

other.
PLEASE BE ADVISED: If you compare this

dishwasher to previous models, you may

be surprised at what you DON’T hear!

Delay Start/Status Lights

Delay Start

(available on select models)

Allows you to delay starting the POTS & PANS

cycle up to 6 hours.
• Turn dial to select number of hours.
• Press POTS & PANS pad.
• Select desired OPTIONS.
• The DELAY START indicator light will come

on when door is closed and remain on as

the timer counts down to begin cycle.

Clean Indicator

(available on select

models)
The CLEAN indicator light will come on when

a cycle is complete. To turn it off, turn dial

slightly until light goes off.

Getting Started

1. Load dishwasher (See Preparing and

Loading Dishes).

2. Add detergent (See Dishwasher Dispenser &

Detergents).

Operating Instructions

(continued)

Latch

Vent

400 Series

3. Add rinse aid, if needed (See Rinse Aid).
4. Select desired cycle (See Cycle Chart). The

indicator will show red when selected.

5. Turn dial clockwise to select cycle or

number of hours for delay start (available

on select models.)

6. Select desired energy OPTIONS (See Energy

Options). The indicator will show red when

selected.

7. If using DELAY START, (available on select

models) go to step number 9.

8. Run hot water faucet nearest dishwasher

until water is hot. Turn water off.

9. To start, close door to latch.