Service – Follett REF5-BB User Manual
Page 8
Service
Latch adjustment
To adjust for proper latch engagement
1. Loosen striker plate mounting screws (Fig. 8.1).
2. Move striker plate up or down as required and tighten screws.
3. Test operation of latch.
To adjust for proper gasket seal
1. Loosen striker depth adjustment screw (Fig. 8.2).
2. Adjust stop in or out and tighten screws.
3. Test operation of latch.
Door gasket replacement
1. Remove existing gasket from mounting track.
2. Verify mounting track is free of any remaining gasket material.
3. Align new gasket with mounting track and press fi rmly in place.
4. Open and close door, checking for proper gasket seal without
pinching against refrigerator.
5. Adjust latch and or striker as necessary for proper door closure.
Slide-out compressor tray
Follett’s slide-out compressor tray allows technicians to partially
slide the condensing unit from the refrigerator back without cutting
refrigerant lines.
1. Remove rear panel (Fig. 9.1).
2. Remove two bolts securing condensing unit to refrigerator base
(Fig. 9.2).
3. Gently slide condensing unit out (Fig. 9.3).
Note: Do not put undue strain on the refrigerant lines.
Removing drawers
1. Pull drawer forward to stop.
2. Lift drawer front to free front rollers from sides.
3. Still lifted, pull drawer forward to free back rollers from sides.
Removing slides
1. Push slides all the way back.
2. Swing bottom of slide away from refrigerator wall and lift slide off of rollers.
8
1
2
Fig. 8
20
82
64
Pro
duc
t
Mod
ule
No.
Ser
vice
No
.
Easton P
ennsylv
ania
MO
TO
R COMPRESSOR T
HER
MA
LL
Y PR
OTECTED
DESIGN PRE
SSURE HIG
H SIDE
MIN.
B
RAN
CH
CIRC
UIT AMP
AC
ITY
MAX.
B
RANCH
C
IR
CUIT FUS
E SIZE
SI
NGLE
PHASE
LO
W SIDE
L
THE
US
A
MADE IN
OZ
PS
IG
R
C
NS
F
UL
PA
RT
N
O
HZ
CHARGE
AM
PS
R
AM
PS
U
VO
LT
S
CORPORA
TION
SERIAL NO
MODEL
FULL LO
AD AMPS
REF
RIGERANT
1
2
3
Fig. 9