FOCUS Enhancements MANL-0823-01 - Manual (Page 43)

CommandPost Programming the Shuttle Wheel
User Guide
31
Entry—actions you program for this position occur
when the shuttle wheel enters that position.
Exit—actions you program for this position occur
when the shuttle wheel leaves that position.
Repeat—when selected, CommandPost repeats the
programming assigned to the Entry button until you
specifically terminate it—that is, you move the shut-
tle wheel to some other position.
To program the Shuttle Wheel:
1. Click the Shuttle Wheel button in the Controller
Options section.
CommandPost displays an enlarged view of the Jog
and Shuttle Wheel with its programmable key posi-
tions. See Figure 2 on page 30.
2. Program the Shuttle Wheel position using the proce-
dures you learned in the preceding sections.
To create multiple keystroke sequences and pauses,
use the procedures described earlier in “Multiple
Key Sequences” on page 23 and “Inserting a Pause in
a Multiple Keystroke Sequence” on page 25.
3. Click outside the Keystroke Entry Box or press Tab to
finish the keystroke sequence.
Shuttle
Wheel
Button