Fisher & Paykel OB60S9DE - Manual (Page 36)

34
1
2
Care and cleaning
Replacing the oven light bulbs
Note: oven bulb replacement is not covered by your warranty.
1 Let the oven cavity and the grill element cool down.
2
Important!
Disconnect the oven from the power supply before continuing.
LEFT LAMP (Fig.9)
3a Remove the left side rack and catalytic panel. See ‘Removing and refitting the side racks and
catalytic panels’.
4a Press down on the lamp cover and rotate to remove.
Important!
Never use screwdrivers or other utensils to remove the lamp cover, as doing so could damage the
surrounding enamel. Only use your hands.
5a Unscrew and replace the bulb with a new one suitable for high temperatures (300 o C) with the
following specifications: 220-240V, 50Hz, E14 and same wattage as the bulb being replaced
(check wattage stamped on the bulb).
6a Refit the lamp cover, operating in reverse order. Make sure that it clicks into place.
Important!
The notch in the inner edge of the cover must be on the side closer to the back of the oven.
7a Refit the left side rack and the left catalytic panel.
8a Turn the power to the oven back on.
9a Set the clock. See ‘Setting the clock and first use’.
TOP RIGHT LAMP (Fig.9)
3b Twist the lamp cover off.
4b Unscrew and replace the bulb with a new one suitable for high temperatures (300 o C) with the
following specifications: 220-240V, 50Hz, E14 and same wattage as the bulb being replaced
(check wattage stamped on the bulb).
5b Twist the lamp cover back on.
6b Turn the power to the oven back on.
7b Set the clock. See ‘Setting the clock and first use’.
Fig.9 Removing the oven light bulbs LEFT LAMP
Notch