Fantom Vacuum FANTOM PT302H - Manual (Page 4)

ROTARY TOOL SYMBOLS
Some of the following symbols may be used on
your tool. Please study them and learn their
meaning. Proper interpretation of these symbols
will allow you to operate the tool better and safer.
WARNING !
SERVICE
Tool service must be performed only by qualified personnel.
Service or maintenance performed by unqualified personnel
could result in risk of injury.
When servicing a tool, use only identical replacement parts.
Follow instructions in the Maintenance section of this
manual. Use of unauthorized parts or failure to follow
Maintenance instructions may create a risk of electric shock or
injury.
SPECIFIC SAFETY RULES
Hold tool by insulated gripping surfaces when performing
an operation where the cutting tool may contact hidden
wiring or its own cord. Contact with a “live” wire will make
exposed metal parts of the tool “live” and shock the operator.
Always make sure the work surface is free from nails and
other foreign objects. Cutting into a nail can cause the bit and
the tool to jump and damage the bit.
Never hold the workpiece in one hand and the tool in the
other hand when in use. Never place the hands near or
below the cutting surface. Clamping the material and guiding
the tool with both hands is much safer.
Never lay workpiece on hard surfaces like concrete, stone,
etc. Protruding cutting bit may cause tool to jump.
V
Volts
A Amperes
Hz hertz
W
watt
kW
kilowatts
microfarads
l
liters
kg
kilograms
N/cm 2
newtons per square centimeter
Pa
pascals
h
hours
min
minutes
s
seconds
alternating current
Always wear safety goggles and dust mask. Use only in well
ventilated area. Using personal safety devices and working in a
safe environment reduces risk of injury.
ALWAYS WEAR EYE PROTECTION. Any power tool
can throw foreign objects into your eyes
which could cause permanent eye damage.
ALWAYS wear safety goggles (not glasses)
that comply with ANSI safety standard Z87.1.
Everyday glasses have only impact resistant
lenses. They ARE NOT safety glasses. Safety goggles
are available at most hardware stores.
Glasses or goggles not in compliance with ANSI Z87.1
could cause serious injury when they break.
After changing the bits or making adjustments, make
sure the collet nut and any other adjustment devices
are securely tightened. Loose adjustment devices will be
violently thrown.
Never use dull or damaged bits. Sharp bits must be
handled with care. Damaged bits can snap during use.
Dull bits require more force to push the tool, possibly
causing the bit to break.
Never touch the bit during or immediately after use.
After use the bit is too hot to be touched by bare hands.
three-phase alternating current
three-phase alternating current with
neutral
direct current
no load speed
alternating or direct current
class II construction
splash proof construction
watertight construction
protective earthing at earthing terminal,
Class I tools
revolutions or reciprocations per minute
Diameter
Off position
Arrow
War ning symbol
ROTARY TOOL SAFETY
SAVE THESE INSTRUCTIONS FOR REFERENCE
This symbol designates that this
tool is listed with U.S.
requirements by Underwriters
Laboratories.
4