FieldServer FS-8700-115 - Manual (Page 13)

FS-8700-115 ASCII Driver (General Purpose) Page 13 of 13
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix B. TROUBLESHOOTING
Appendix B.1. Driver Specific Stats
Message Description
IC Timeout If the Driver is waiting for EndPart_String to arrive and the inter-character timeout (default 0.5s)
elapses before the end of stream character has been received the driver stats it as IC_Timeout,
clears the incoming buffer and waits for the beginning of the next stream.
Timeout If driver is configured to send a poll and is unable to transmit the entire poll message within the
Timeout period (default 2s), the Driver will stat this as Timeout.
Appendix B.2. Driver Error Messages
Error Description and Corrective Action
ASCII:#1 FYI. Port \"%s\"
Connection Parameters Can
Be Changed Remotely
You can safely ignore this message. It is designed to make you aware of the
capability of the driver. Refer to Appendix A.2
ASCII:#2 FYI. Port \"%s\"
Setting Changed Remotely.
New Setting: %s
You can safely ignore this message if the setting reported match your expectations.
The driver is reporting that connection settings have been changed. The change
resulted from a change to the FieldServer registry settings and this driver has been
notified to start working with the new settings.
ASCII:#3 FYI. Port \"%s\"
Initial Setting:%s
Start Char 0x%2X End
Char 0x%02X Termination
Time %fs
The driver is reporting initial settings for the port. The message is for your
information only and no corrective action is required if it confirms you expectations.
If it doesn’t review and correct the configuration file or registry.ini file.
ASCII:#4 Extracted max %d
values, ignoring others.
The message will get printed out when the driver has extracted the maximum
number of supported values from the ASCII message. The driver won't process the
message further.
If more values are required, contact sales at FieldServer Technologies.
ASCII : Retiring MD<%s>
from
polling, All poll
messages have been sent
The driver is reporting that all configured polling message have been sent. No
further polling message will be sent using the Map Descriptor.
The message is for your information only and no corrective action is required if it
confirms your expectations. If it doesn’t review and correct the configuration file.