FORD 2000 Explorer - Manual (Page 118)

3. Within five seconds of turning the ignition to OFF, insert the second
previously programmed SecuriLock
௢ key into the ignition and turn the
ignition from OFF to ON (maintain ignition in ON for at least one second
but no more than five seconds).
4. Turn the ignition to OFF and remove the second SecuriLock
௢ key
from the ignition.
5. Within 10 seconds of turning the ignition to OFF, insert the
unprogrammed SecuriLock
௢ key (new key/valet key) into the ignition
and turn the ignition from OFF to ON (maintain ignition in ON for at
least one second). This step will program your new SecuriLock
௢ key.
6. To program additional SecuriLock
௢ key(s), repeat this procedure from
step 1.
If the programming procedure was successful, the new SecuriLock
௢
key(s) will start the vehicle’s engine. The theft indicator (located on the
instrument cluster) will light for three seconds and then go out.
If the programming procedure was not successful, the new SecuriLock
௢
key(s) will not operate the vehicle’s engine. The theft indicator will flash
on and off. Wait at least one minute and then repeat the procedure from
step 1. If failure repeats, bring your vehicle to your dealership to have
the spare SecuriLock
௢ key(s) programmed.
Controls and features
118