Furuno ETR-30N - Manual (Page 28)

10
SNDR
SETUP
EDIT
RETURN
TRANSDUCER SETUP MANUAL
HIGH FREQUENCY --kHz
(0kW TAP:-)
LOW FREQUENCY --kHz
(0kW TAP:-)
TAP SETTINGS MUST BE MADE ON
ETR UNIT.
AFTER SETUP, DISPLAY MUST BE
TURNED OFF & ON TO ALLOW
NEW SETTINGS TO TAKE EFFECT.
Frequency setup screen
3. TRANSDUCER SETUP is selected; press the EDIT soft key.
MODEL NUMBER
MANUAL
TRANSDUCER SETUP
Transducer type setting method options
4. Use the [ENTER] knob to choose MODEL NUMBER and then push the [ENTER] knob.
5. Use the [ENTER] knob to choose HIGH FREQUENCY and then push the [ENTER]
knob.
HIGH FREQUENCY
28kHz 28F-8
28kHz 28F-18
28kHz 28F-24H
38kHz 38E-9-18S1
45kHz 45F-12H
50kHz 50B-6/6B
50kHz 50B-9/9B
50kHz 50F-8G
50kHz 50/200-1ST
50kHz 50/200-1T
Frequency options
6. Rotate the [ENTER] knob to choose transducer and then push the [ENTER] knob.
7. Confirm tap position at the SNDR SETUP screen.
8. If a low-frequency transducer is installed, set it following this procedure.
9. Turn off the NavNet display unit.
10. Turn on the NavNet display unit. Confirm that the echo sounder picture advances.