Fisher-Price JEEP AFTERSHOCK 74270 - Manual (Page 16)

• Fit the back half of the windshield frame onto the front
half of the windshield frame. Make sure the slots at the
bottom of the two windshield frame halves are aligned.
• Insert ten #8 x 1 1 /
4
" screws into the back half of the
windshield frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Helpful Hint! Squeeze the two windshield halves together
while tightening the screws.
• Lift the assembled windshield to the raised position.
Slots
Windshield Frame –
Front Half
Windshield Frame – Back Half
20
Assembly
21
23
• With the lip on the hood prop base facing down, align
the hole in the hood prop base with the hole in the
vehicle body near the battery compartment. The hood
prop base should lay flat on the vehicle body.
• Insert a #8 x 3 /
4
" screw through the hole in the hood
prop base. Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
16
• Snap the tabs on the bottom of the air scoop into the
slots on the top of the engine housing.
• Fit the pretend spark plug wires onto the pretend
spark plugs.
22
• Gently squeeze the ends of the prop arm to fit them
under the arm retainers on the hood prop base.
• Release the ends of the prop arm under the retainers.
Hood Prop Base
Air Scoop
Spark Plug Wire
Spark
Plug
Engine
Housing
Prop Arm
Prop Arm