FieldServer FS-8700-66 - Manual (Page 9)

FS-8700-66 GE-SNP Driver Manual Page 9 of 28
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
GE Port Defaults
Parameter Series 90-30 PLC’s Series 90-70 PLC’s
Baud 19,200 19,200
Data Bits 8 8
Parity Odd Odd
Stop Bits 1 1
Max Link Idle Time 10 Secs 5 Secs
GE Port Capabilities
Parameter Legal Values
Baud 300, 600, 1200, 2400, 4800, 9600, 19200
Data Bits 8
Parity Odd, Even, None
Stop Bits 1, 2
Max Link Idle Time 1 to 60 Secs
5.2 Client Side Node Descriptor Parameters
Section Title
Nodes
Column Title
Function Legal Values
Node_Name
Provide name for Node. The driver uses the
Node name to establish a connection with the
Server if the Node_ID is non-zero.
If the Node_ID is zero then the driver ignores
the Node name when logging onto the PLC and
logs on using a Null nameThsu the driver is able
to log onto a Node whose name is unknown.
Up to 32 alphanumeric characters
Node_ID*
The parameter is used in conjunction with
Node_Name to control how the driver logs onto
the PLC
0,1
Protocol Specify protocol used SNP
Port
Specify which port the device is connected to
the FieldServer
P1-P8, R1-R2
2
SNP_Longbreak*
Number of characters used to calculate the
time for the specified baud rate at which the
FieldServer will send a break signal to the PLC.
1-65535, 4
SNP_Break_Offdelay*
Delay (in milliseconds) before a message is sent
to the PLC from the FieldServer after the break
is released.
1-65535, 70
2 Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available
on specific hardware.