Fisher & Paykel DW60CE - Manual (Page 36)

34
Using rinse aid
We highly recommend using liquid rinse aid regularly to get the best drying results. Rinse aid
gives a streak-free, sparkling clean look to glass and chinaware. In addition, it prevents metal
from tarnishing.
When to refill the rinse aid dispenser
When rinse aid level becomes low, the rinse aid
indicators on the dispenser and the control
panel will light up to remind you to refill the dispenser.
Adjusting the rinse aid dosage
The normal, factory-set dosage level is 4, but you
may need to adjust this to suit your water conditions.
Insert a flat-bladed screwdriver into the slot of the
dosage regulator arrow, and turn it to the desired level.
If there is excessive foaming at the end of the wash,
reduce the dosage.
If you live in a hard water area or if dishes are wet or streaky
after drying, increase the dosage.
If you are using tablets with built-in rinse aid, we
recommend setting the rinse aid dosage level to 1.
On CC models, you may wish to turn the rinse aid off
altogether and/or select the correct detergent type
(tablet with rinse aid).
See section ‘User preference settings’ for how to do this.
How to refill the rinse aid dispenser
1 Press the button to snap the dispenser cover open.
2 Pour rinse aid into the circular opening, making sure not
to fill beyond the MAX marking.
Important!
Take care not to spill rinse aid into the dishwasher. Any spills
must be wiped up to prevent excess foaming. Failure to do so
may result in a service call, which will not be covered by warranty.
3 Close the cover, making sure it clicks shut.
READY
TO WASH
NO D Normal
Rinse aid indicators
CE models only
CC models only
Press to open
Dosage regulator