beautypg.com

Parts supplied, Cavity preparation, Important – Fisher & Paykel DD24DT User Manual

Page 3

background image

2” x 4”

PARTS SUPPLIED

Clamp (1)

Wire clip (2)

Phillips

16 mm

screws (9)

Drain hose

support (1)

Moisture protection

tape (1)

(to prevent moisture

damage)

Drain hose

joiner (1)

Top

mounting

brackets (2)

Side mounting

bracket kit

(A and B) (2)
OPTIONAL

Prefinished toekick (1)

white or black

Washer (1)

Edge protector (1)

(if services hole

partition is metal)

If the Drain hose(s) supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose(s) by 11’ 10” (3.6 m). The kit is available from the nearest
Fisher & Paykel Authorized Service Agent, or Toll free 1.888.936.7872 or www.fisherpaykel.com.

Hexagonal

socket (2)

(long & short)

Important!

Be sure the edges of the services hole are smooth or covered. If the services
hole is through a metal partition the hole must be protected with the Edge
protector supplied to prevent damage to the power cord or hoses.

These marks indicate mounting bracket screw locations

Preferred position. If adequate clearance, services hole can be
higher to clear toekick space.

If hole is higher, ensure drain hose(s) are routed straight into the
waste connection.

Water Connection

Recommended HOT (Maximum 140°F/60°C).

Supplied hose to suit 3/8” (9 mm) male compression fitting.

*

110-120 VAC
max. 15 A

Note: S

ervices can be locat

ed

either side of DishDra

wer®.

max. ø

1

½

(38 mm)

*

*

min.

7

7⁄8

(200 mm)

3⁄8”

(10 mm)

max.

17

11⁄16

(450 mm)

If no side partition, use a

brace for securing.

CAVITY PREPARATION

4

5

Water Pressure

Max

Min

Water softener models

1 MPa (145 psi)

0.1 MPa (14.5 psi)

Other models

1 MPa (145 psi)

0.03 MPa (4.3 psi)

Drains will need to be separated to satisfy kosher requirements. We suggest you confirm
acceptability with your local rabbi in respect to kosher installations.

Left hand

side

Right hand

side

Water supply

Moisture

protection

tape must

be applied.

Max. distance of
hoses and cord from
chassis edge

Left hand

side

Right hand

side

Drain hose

78 ½

(2000 mm)

70 ½

(1800 mm)

Inlet hose

64 ¾

(1650 mm)

49”

(1250 mm)

Power cord

(excl. plug)

29 ½

(750 mm)

27 ½

(700 mm)

(2,1) -1- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:50:45 AM

(2,1) -1- 599632C DD24D TALL installA2 USCA.indd 15/4/09 11:50:45 AM