Hoover Plus - Manual (Page 4)

Press cord into cord clip on back of
handle. Pull cord tight.
4
The assembled cleaner will look like this
drawing (Plus model shown).
1-2
Attach upper handle
Remove clean solution tank (upper tank)
from deep cleaner.
With cord hook (A) to back of deep cleaner,
push upper handle down onto lower han-
dle. Push
b o l t s into holes on front of han-
dle. If bolts will not go through hole easi-
ly handle is not pushed completely
d o w n .
1-3
1-6
1-7
Attach hose holder
Position hose holder (B) onto handle by
matching tabs on rack with openings on
back of handle. Make sure holes for
bolts are aligned.
1-8 1 - 9
Place nuts in recessed areas on back
of the hose holder. Hold each nut in
place while tightening each bolt securely
(from the front of the handle) with a
Phillips screwdriver.
Only two nuts are needed on this model.
The extra nut is not required but has
been provided for your convenience.
A
C
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod In place.
Replace clean solution tank (upper tank)
by positioning bottom first. Press on
tank handle to snap top of tank into
place. Attach tool holder
Remove tool and taped screw from
holder.
Insert projections on rack into slots on
back of cleaner.
Assemble handle
1-4
B
1-5