Harbor Freight Tools 95310 - Manual (Page 11)

Page 11 For technical questions, please call 1-800-444-3353. Item 95310
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
General Operating Instructions
1. If an automatic oiler is not used, add a few
drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
2. Connect the air hose to the air inlet of the tool.
3. If tightening the nut, tighten by hand
as much as possible first.
4. Place the socket over the nut.
5. Grip the Impact Wrench firmly with two
hands and squeeze the Trigger.
6. If the tool requires more force to accomplish
the task, verify that the tool receives sufficient,
unobstructed airflow (CFM) and increase the
pressure (PSI) output of the regulator up to the
maximum air pressure rating of this tool.
cAUTION! TO pREVENT INJURy FROM
TOOL OR AccESSORy FAILURE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
7. To prevent accidents, turn off the tool, detach
the air supply, safely discharge any residual air
pressure in the tool, and release the throttle and/
or turn the switch to its off position after use.
cAUTION! Impact Wrenches are not
intended to tighten to a specific torque.
If a specific torque reading is needed,
use a torque wrench to tighten the nut to the
proper setting after using the Impact Wrench.
8. Clean external surfaces of the tool with clean,
dry cloth, and apply a thin coat of tool oil.
Then store the tool indoors out of children's reach.