HONDA 2010 Element - Manual (Page 270)

Replacing a Side Turn Signal Bulb
1. If you are changing the bulb on the
driver's side, start the engine, turn
the steering wheel all the way to
the left, and turn off the engine. If
you are changing the bulb on the
passenger's side, turn the steering
wheel to the right.
2. Use a Phillips-head screwdriver to
remove the three holding screws,
and remove the wheel arch
protector from the inner fender.
3. Use a flat-tip screwdriver to
remove the holding clip from the
inner fender.
4. Pull the inner fender cover away
from the fender.
5. Remove the socket from the turn
signal assembly by turning it one-
quarter turn counterclockwise.
6. Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
7. Insert the socket back into the
turn signal assembly. Turn it
clockwise to lock it in place.
8. Turn on the lights to make sure
the new bulb is working.
WHEEL ARCH PROTECTOR
SCREWS
CLIP
Lights
264