Hafler GX2800CE User Manual

Page 22

1. Connect signal from source to CH B input.
2. Biamp/Stereo switch not active (Stereo/Mono switch

overrides this switch when in mono/70V/100V mode).

3. Move Stereo/Mono switch to 100V mode.
4. Select 100V load, both channels.

5. Connect parallel array of 100V transformer-equipped

speakers across the red terminals of the 5-way binding
posts. CE units: Wire SPEAKON as shown above and
connect to CH A output.

6. CH B input sensitivity controls 100V mono output level.

Amplifier will clip at 100Vrms level.

1. Connect signal from source to both CH A and CH B inputs.
2. Move Biamp/Stereo switch to Stereo mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select 8

Ω speaker load for each channel.

5. Connect parallel array of 70V transformer-equipped

speakers (up to 700W per channel) to 5-way binding
posts. CE units: Connect as shown above for Dual
SPEAKONs or Single 4-Wire SPEAKON.

6. Adjust CH A and CH B level controls independently.

100V MONO MODE

70V STEREO MODE

CE SPEAKON
Connector
Wiring

Connect to CH A output

– 20 –

This manual is related to the following products:

GX2800