Hafler GX2800CE - Manual (Page 20)

– 18 –
1. Connect signal from source to both CH A and CH B
inputs.
2. Move Biamp/Stereo switch to Stereo input mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select desired speaker load (8
Ω/4Ω/2Ω) for each
channel – CH A & CH B loads do not need to match.
5. Connect appropriate speaker load 8 Ω/4Ω/2Ω to 5-way
binding posts. CE units: Connect as shown above for
Dual SPEAKONs or Single 4-Wire SPEAKON.
6. Adjust CH A & CH B level controls independently.
1. Connect signal from source to CH B input.
2. Move Biamp/Stereo switch to BIAMP input mode.
3. Move Stereo/Mono switch to Stereo mode.
4. Select desired speaker load (8
Ω/4Ω/2Ω) for each
channel — CH A and CH B loads do not need to match.
5. Connect appropriate speaker load 8 Ω/4Ω/2Ω to 5-way
binding posts. CE units: Connect as shown above for
Dual SPEAKONs or Single 4-Wire SPEAKON.
6. Adjust CH A & CH B level controls independently.
Wiring Diagrams
STEREO MODE
BIAMP MODE
CE SPEAKON
Connector
Wiring
CE SPEAKON
Connector
Wiring