haier HWM88-0566T - Manual (Page 9)

RESERVE
PROCESS
WATER
LEVE
L
SOAK
WASH
RINSE
SPIN
1
2
3
4
RESERVE(HOURS LATER)
TIME REMAINED(MINUTES)
Description of operation button
a
5 Use the operation buttons
" " Process button
With it you can select one or
several processes of soak,
wash, rinse and spin.
Connection between the water inlet hose and the washer
1. Do not take off the water absorption cushion. Please check if the
cushion is dropped or damaged before each usage. If it happens
please contact our after-sale department immediately.
2 Put the nut of the water inlet hose on the valve jointer.
3 Fasten the nut. Swing it gently to confirm if it's suitable.
nut of the water
inlet hose
jointer of the
water inlet valve water absorption
cushion.
Connection between the jointer of the water inlet hose and the water inlet hose
1. Push down the slider. Insert the water inlet hose into the jointer.
2 Hang the lock lever to the jointer. Release the slider till a click
sound is heard.
Locking level
the jointer of the
water inlet hose
Slider
Check the connection between the jointer of the water inlet hose
and the water faucet
1. Swing the hose gently to confirm if it is fastened stable.
2.After installation, open the faucet to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection
between the jointer of the water inlet hose and the
water faucet, and the installation of the water inlet
hose are firm, so as to prevent dropping from
improper installation position.
Dismantle the water inlet hose
1. Close the water faucet.
2. Press the locking lever. Push down the slider. Then pull of the water inlet
hose.
If the machine is used frequently, the jointer of the water inlet hose can be
kept
on the faucet to prevent damaging the fixing screw.
Locking level
Slider
"Water level" button "Reserve" button
The digitron displays remain time
before washing is finished (in minutes)
Push "reserve" button, the digitron
displays the reserve time of washing
(in hours). The indicator flashes to
indicate that the reserve function is
operating.
Push "reserve" button to display
the reserve mode. During the standard program,t he washing machine
can detect the laundries automatically. After
detection,it will set the water level to suitable value
among 1, 2,3,and 4 automatically
.
You can also set water level by yourself. After the
machine is started, it will not set water level
automatically. You shall push the start/pause
button to make new setting.
If save program is selected, it will display water
level 2 . When water level 1 is reached in water
filling, it will perform washing while filling water.
When water level 2 is reached, it will change to
normal washing.
Indicator mode and meaning
Flashing: indicate the running program
On: indicate the program about to run, or
indicate the selected mode
Off: