beautypg.com

Troubleshooting – Hotpoint WMM65 User Manual

Page 25

background image

Troubleshooting...

The ‘Time to End’ display jump...

● The estimated programme times are

dependant on the temperature and
pressure of the incoming water supply,
the option(s) selected and the load being
washed. They may, therefore change
during the fill stages of each programme
to take into account the extra heating or
fill time required.

The programme takes a long time...

● Some programmes do take a long time.

Things which can lengthen the
programme time include low
temperature and low pressure of the
incoming hot water supply, or low cold
water pressure.

The machine makes a noise or vibrates
during a spin programme...
If the noise is very loud you should check
whether:
i) You have removed the transit bolts.
ii) You have removed the polystyrene block.
iii)You have correctly adjusted the feet to

stabilize the machine.

iv)You have removed loose items such as

coins from pockets, as these can rattle
about inside the machine drum and
cause damage.

The laundry has not spun dry...

● Is the ‘Spin’ progress status light flashing?

If so, see the next section,‘The ‘Spin
progress status light is flashing’.

● Did you use a short spin programme?

If so, try again using a faster spin
programme.

● Did you reduce the spin speed of the

selected programme using the ‘Variable
Spin
’ option control button?
If so, select a faster spin programme.

● Did you use the ‘F.Fwd’ option and

skipped through the spin cycle?
If so select a Spin only programme.

The ‘Spin’ progress status light is
flashing...

● This means that there has been an

unbalanced load and the machine could
not spin.
See ‘Unbalanced Load Warning’ in the
PROGRAMMES & OPTIONS section.

Water collects in the detergent
dispenser compartment...

● Is the retaining flap in the down position.

Lift to allow the water to drain away.

The dispenser drawer will not close
properly...

● Please check that the drawer is properly

aligned.

● Is the drawer clogged with detergent?

(see: CLEANING & MAINTENANCE).

Steam is coming from the dispenser
drawer...

● We have designed the machine to release

steam from the dispenser drawer during
hot washes, so don’t worry.

Suds are coming from the dispenser
drawer...

● Have you used the correct low suds

automatic detergent?
See ‘The Dispenser’ - Choose a suitable
detergent.

● If you have used the wrong type of

detergent, flush out your machine by
choosing a rinse programme.

Not all of the detergent has been flushed
away...

● Check that your water supply taps are

turned on fully.

● Check the inlet hoses are not kinked.
● Is your hot water pressure low? If so

you may need a cold fill adaptor to run
your machine as cold fill only.

● Ensure the detergent flap is in its ‘up

position when dispensing powder and
down’ for dispensing liquid.

The flap keeps falling down...

● As you push the flap to the up position

you will feel some resistance, increase the
pressure and the flap will move to its
home position.

If the machine is still not working contact
Hotpoint Service, see the back page.

Remember, you may be charged for a
service call if a problem with your
machine is caused by incorrect
installation or misuse.

25

TR
OUBLE

SHOO

TING

This manual is related to the following products: