Hotpoint RCNAA53 - Manual (Page 9)

GB
9
Care and
Maintenance
• Remove the ice from the upper edge (see the
Troubleshooting Guide).
• Clean the inside after defrosting, using a sponge
dampened with warm water and/or mild detergent.
• Clean the side motor cooling grille (depending on
model).
• Remove dust from the condenser on the rear of
the appliance.
Before carrying out maintenance, unplug the
appliance.
Do not use abrasive products, scourers or stain-
removers (e.g. acetone, trichloroethylene) to clean
the appliance.
To obtain the best results from your appliance, carry
out cleaning and maintenance at least once a year.
CHANGING THE LID LIGHT BULB (IF PROVIDED)
• Disconnect the appliance from the mains power
supply.
• Remove the diffuser
by following the
sequence of steps
shown in the figure.
• Unscrew the light bulb and replace it with an
identical bulb of the same wattage and voltage.
• Refit the diffuser and plug in the appliance.