Hitachi VT-M190A - Manual (Page 41)

IRT (INSTANT RECORDING TIMER)
41
Press STOP/EJECT button on the VCR.
If you are recording using the Automatic Timer Program, you may not operate the unit
manually, but, you may still stop the recording by pressing STOP/EJECT button on the
VCR.
NOTE: STOP button on the remote control will not function in the Automatic Timer
Recording mode.
AUTOMATIC TIMER RECORDING HINTS
If there is a power failure of the VCR is unplugged for more than 30 seconds, the
clock setting and all timer settings are lost.
If the tape runs out before The end time, the VCR will switch to the STOP mode
immediately, eject the tape and the VCR power will be turned off. The " " indicator will
flash.
If a tape is not inserted or the erase-protection tab is removed, the " " indicator
flashes and automatic timer recording cannot occur. Insert a tape that allows recording.
The TV that is connected to your VCR may be turned ON or OFF when the VCR is in
the timer-record mode.
IRT (INSTANT RECORDING TIMER)
The Instant Recording timer function enables you to record a program simply by
pressing IRT button on the VCR. According to the table, simply press IRT button as
many times as needed to set the desired recording length. The channel number to be
recorded and recording length will be shown on the display.
1
Turn on the VCR.
2
Set the VCR to the channel to be recorded.